磁控濺射制備CrMoAlN梯度薄膜的抗高溫氧化性能磁控濺射制備CrMoAlN梯度薄膜的抗高溫氧化性能High temperature oxidation resistance of CrMoAlN gradient coatings prepared by unbalanced magnetron sputtering 采用非平衡磁控濺射離子鍍技術在M2工具鋼和單晶Si表面沉積CrMoAlN梯度薄膜，并在靜態空氣中進行600、700、800、900 ℃的高溫氧化實驗。采用XRD、SEM、XPS、納米壓痕和劃痕實驗等研究，結果表明：CrMoAlN薄膜呈現與CrN相似的面心立方結構，主要以CrN、AlN和γ-Mo2N形態存在。經800 ℃氧化2 h后，CrMoAlN薄膜基本保持常溫時的晶體結構與力學性能。隨著氧化溫度繼續升高，薄膜表層的MoO3加速揮發，破壞由Cr2O3和Al2O3組成的致密氧化層，薄膜表面出現細小孔隙，薄膜氧化程度加劇。經900 ℃氧化2 h后，CrMoAlN薄膜的力學性能和膜/基結合強度均出現明顯下降。 CrMoAlN gradient coatings were deposited on M2 and silicon wafers by closed-field unbalanced magnetron sputtering ion plating(CFUMSIP)technique, and their high-temperature oxidation behaviours were studied after static oxidation tests in air at different temperatures (600, 700, 800, 900 ℃) for 2h. The chemical composition, structural, hardness and adhesive/cohesive strength of the coatings were characterized by EDS, XRD, XPS, SEM, nanoindentation and scratch test. The experimental results show that CrMoAlN coatings exhibit a single phase cubic structure. After oxidation at 800 ℃ for 2 h, the CrMoAlN coatings still retain basically their crystalline structure and mechanical properties. The volatilization reaction rate of MoO3 increases, the dense and protective oxide layer consisting of Cr2O3 and Al2O3 is broken. The porous become clearly observable on the surface of the coating, which provides fast diffusion paths for oxygen and cations, and thus promotes the growth rates of oxide scales. After oxidation at 900 ℃ for 2 h, the mechanical properties and adhesive strength decrease drastically. 全文下載：http://pan.baidu.com/s/1kVQM19t
|
